ZhongTaiko (6-Button White E-Box) — Firmware Update & Web Config Tool
On
A big update for the 6-button White E-Box: firmware v1.12.0 plus a browser-based web config tool — no install, and your settings live right on the controller.
✨ What's New — Firmware v1.12.0
🎮
3 modes, live-switchable
PC (Keyboard + Gamepad) / Nintendo Switch / MIDI — switch on the fly.
🎯
Advanced detection
Tunable crosstalk suppression, self-lock time, buffer delay, and roll-detection window.
⚡
Limit-boost
Automatically takes over alternating output once you pass your set roll rate — push those roll scores higher.
📌
Mode memory
Switching via pin or web is saved to EEPROM and survives a replug.
💾
Export / Import JSON
Back up and share your settings in one click.
🔧 Web Config Tool (no install)
Open the Web Config Tool →Requires Chrome or Edge on desktop (WebHID).
- Open the link in Chrome / Edge (WebHID required).
- Connect the controller via USB.
- Click Connect and pick your device in the popup.
- Adjust key mapping, detection thresholds, and limit-boost.
- Click Save to write the settings to the controller.
- Use Export JSON to back up, Import JSON to restore.
💡 Settings live on the controller itself — no re-setup when you move to another PC.
📥 Firmware Update
- Open the web tool and check your current version (shown top-left).
- Follow the in-tool Flash instructions to update.
- After flashing, reconnect the controller.
Questions, bug reports, or setup sharing — drop a comment below! 🥁